Gandolph
10-22-2009, 08:05 PM
My project contains 6 cut outs, two of which have smaller cut paths within them. The problem is that there were no tabs left on any of the cut paths and the individual pieces shifted as the 3rd pass was cut with a max depth pass set at "0.250" on 3/4" pine stock. Why were there no tabs cut when the cut path properties box indicated a minimum number of tabs set at 3, and 3 tabs per foot with a max depth pass at 0.250"? The cut path tabs
of earlier projects were always present. Is there a way to program in exactly where I want tabs left?
Gandolph
of earlier projects were always present. Is there a way to program in exactly where I want tabs left?
Gandolph