woodwright706

[woodwright706]

I am still learning and have a problem. wile carving a Mandolin back in a piece of maple it stoped gave me a clean y axis message. I cleaned the machine well wasn't dirty really then pressed enter. Then the machine started for about 2 seconds then gave an error and said press stop. well I am 3 hrs. into a 4 hour job is there a way to reload and start where it left off? Also what can I do to prevent it from happing again? I have carved two of them this week and it did very well. Thanks In advance Woodwright706

[dbfletcher]

please take a look at this thread.

http://forum.carvewright.com/showthread.php?t=13137 (go back the the earlier posts in this thread)

Doug Ftetcher

[woodwright706]

I found what caused my machine to shut down it was the flex cable come out of the collar that plugs into the bit carrier. So I took the old faithful super glue and put it back, now its making sawdust. Woodwright706