Basset slave
10-19-2009, 07:55 AM
Yup, it's finally over!! Hubby has decided that he's tired of his machine and wants to sell it. I'll be posting something on Craigslist as well as here.
The machine has 342 hours, 25 minutes on it. Lately he has been running into quite a few Z axis stall errors and the last few times he has tried to use it, the cutting bit doesn't go down to the board.
He's not computer savy and can not navigate the forums. And I'm getting sick and tired of searching the forums, which by the way have been extremely helpful, and then trying to make him listen to me to problem solve.
So, if anyone is interested in this, he is asking $500, buyer pays shipping (would be shipped from Omaha) and there is a no money back guarantee...once it's gone, I don't want it back in the garage.
You can send PM's here, e-mail me at either welchsx3@cox.net or swelch@unmc.edu
Thanks for all the wonderful hints, helps and advice that you have provided within this forum.
The machine has 342 hours, 25 minutes on it. Lately he has been running into quite a few Z axis stall errors and the last few times he has tried to use it, the cutting bit doesn't go down to the board.
He's not computer savy and can not navigate the forums. And I'm getting sick and tired of searching the forums, which by the way have been extremely helpful, and then trying to make him listen to me to problem solve.
So, if anyone is interested in this, he is asking $500, buyer pays shipping (would be shipped from Omaha) and there is a no money back guarantee...once it's gone, I don't want it back in the garage.
You can send PM's here, e-mail me at either welchsx3@cox.net or swelch@unmc.edu
Thanks for all the wonderful hints, helps and advice that you have provided within this forum.