Tracking Sensor Fault Error 315

[crimsonwhite]

Trying to start a new project. I keep getting "Tracking sensor fault Error 315". What do I need to do to correct the problem?

[Digitalwoodshop]

The Brass Roller between the belts is causing your problem....

It must be loosing contact with the wood... It measures and tracks the board movement in the X Direction....

Head Pressure could be light... Not holding the board to the roller....

Wood might be warped or be missing wood near the edge.

Masking Tape might help... It gives the brass roller something to bite into.

Using a short board and when the board is being only held my one roller it tilts up loosing contact with the roller...

Roller missing the rubber O Ring...

Sawdust around the brass roller....

In feed or Out Feed tables out of adjustment....

Tips and Tricks has a ton of other GREAT stuff to learn....

Good Luck,

AL