IBTech
05-11-2006, 08:07 PM
I've been having a problem with the left Z Axis Guide Rail dropping down during a project (the rails on either side of the router head). I first noticed it when the rail dropped low enough to start to scare the top of the wood. It's tight enough that I can't slide it back up by hand. I found that gently tapping it with a hammer will slide it back into position. But slowly as the next project progresses, it starts working it's way back down again.
Has anyone else had this happen? Does anyone know of a way to keep it in it's delivered position?
Has anyone else had this happen? Does anyone know of a way to keep it in it's delivered position?