DigitalDave
10-01-2009, 02:27 PM
Hey guys,
While doing a project, I got a Z-axis stall. As I was checking things out I noticed that the flexshaft (bit end) was loose. When I removed it from the bit the cap separated from the shaft. Does this mean a new flexshaft assy. or is this an epoxy job? It appears, looking at the shaft housing and inside the cap, that it was epoxied originally. Any comments would be appreciated. If re-epoxy, what product would be best?
Dave
While doing a project, I got a Z-axis stall. As I was checking things out I noticed that the flexshaft (bit end) was loose. When I removed it from the bit the cap separated from the shaft. Does this mean a new flexshaft assy. or is this an epoxy job? It appears, looking at the shaft housing and inside the cap, that it was epoxied originally. Any comments would be appreciated. If re-epoxy, what product would be best?
Dave