PDA

View Full Version : What happened?



wasacop75
09-26-2009, 03:31 PM
There is a 4 1/2 in gap in this carving.
The N in Unique and between the E and A in Creations
has a huge gap in it..... there was not an electric flicker
i was in the garage the whole time, i did not use
any other electric tools. Any idead?

I will try to post the mpc

DocWheeler
09-26-2009, 05:23 PM
wasacop75,

The only thing that I could suggest is that the brass roller skipped a good bit of your board. Might check to see if the rubber "damper" is in place under the brass roller assembly.

Al should say something about masking tape about now!

chebytrk
09-26-2009, 06:40 PM
wasacop75,

The only thing that I could suggest is that the brass roller skipped a good bit of your board. Might check to see if the rubber "damper" is in place under the brass roller assembly.

Al should say something about masking tape about now!

He has stock in it... you know! Gotta push it!

wasacop75
09-26-2009, 06:59 PM
There was tape on it... Thats what gets me.....

DocWheeler
09-26-2009, 08:31 PM
Check the tape and see if you see the tracks from the brass. I would bet that the tracks disappear for about 4 inches.

mtylerfl
09-26-2009, 10:30 PM
There was tape on it... Thats what gets me.....

...see this post: http://forum.carvewright.com/showpost.php?p=104781&postcount=4

(PS - try not to post the same question twice in the forum - aka "double-posting")