jwshukis
09-25-2009, 10:42 AM
My Z axis was getting a bit "crunchy". Not serious your-belt-screws-are-loose crunchy, but just a bit of hesitation in one spot when moving up and down.
I believe that a previous incident where I broke a bit in hard Mahogany caused it. I disassembled the Z-truck and found that the metal rods on which the z-truck rides up and down had very small dents in them. The fix was very easy - remove the rods and rotate them 180 degrees so that the dents no touched the z-truck at all.
This very obvious fix wasn't very obvious to me before I opened up the machine. Perhaps it will be useful for someone else.
Jeff
I believe that a previous incident where I broke a bit in hard Mahogany caused it. I disassembled the Z-truck and found that the metal rods on which the z-truck rides up and down had very small dents in them. The fix was very easy - remove the rods and rotate them 180 degrees so that the dents no touched the z-truck at all.
This very obvious fix wasn't very obvious to me before I opened up the machine. Perhaps it will be useful for someone else.
Jeff