View Full Version : Strange read outs
I noted that my LED has started to display random letters and #s while I go though the set up. They start all the way to the right and work further left only on the top line? Any ideas
Thanks
Digitalwoodshop
09-17-2009, 09:16 AM
Reformat the card.
If that does not do it, order a new keypad.
AL
Reformat the card.
If that does not do it, order a new keypad.
AL
Thanks Al you the man
mtylerfl
09-17-2009, 07:52 PM
Hello Hess,
If you need to replace your LCD anyway...
You might want to get the one from Jeff Birt - it is a backlit LCD and will be much easier to read.
Only $38.50 at http://soigeneris.com/soigenerisprd.aspx
Digitalwoodshop
09-17-2009, 09:56 PM
I hoped or hope reformatting the card fixes it....
I closed the deal on Machine #4 tonight, the bank check goes out tomorrow.:p:p:p:p
I can have 4 times the fun..... That will cut down on that 3 weeks of carving.... Running 2 or 3 machines....
AL
SAA3840
09-18-2009, 12:20 AM
Before you buy a new keypad, try what I suggested to Northwoods Woodcrafter on another thread. Replace the flat cable going from the keypad to the computer. As I told him, your problem sounds similar but not exactly like what I had. I replaced the cable and the problem went away. Parts cost me about $5.00 and took about 10 minutes to install it.
liquidguitars
09-18-2009, 12:26 AM
Could also be a bad flash card .. At one time I think we had a low level format option..
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.