Mike Witt
09-16-2009, 12:57 PM
I have the files saved from the state quarters patterns of each state, I am attempting to carve the state of texas and when I open this state I get the outline as a carve area.
I would like to carve only the outline at approximatelt .085 deep as it might carve in centerline with the 60 degree bit but after several tries I keep barking up the wrong tree.
I know it is prolly something simple but this old man can't seem to get it right
Thanks in advance
Mike:confused:
guisado@elp.rr.com
I would like to carve only the outline at approximatelt .085 deep as it might carve in centerline with the 60 degree bit but after several tries I keep barking up the wrong tree.
I know it is prolly something simple but this old man can't seem to get it right
Thanks in advance
Mike:confused:
guisado@elp.rr.com