John
04-24-2006, 11:41 PM
Spent a few hours this past weekend putting together a new home for the Carve Wright. The top has a downdraft type dust collection built into it to hook up to the dust collector. Probably won't do much when the project maxes out on the width, but hoping for good results otherwise. Still need to make some ext. rollers before there are any long projects. Question for CW staff. I noticed when tighting down the machine to the top, it is quite easy to compress the feet so there is no gap. I backed the bolts off a little to make sure there was some air movement. Question is: Would it be a good idea to cut ventilation holes in the top of the cab. to allow better air circulation? These holes would be separate from the dust collection ports.
http://i30.photobucket.com/albums/c348/johnluard/cw3.jpg
http://i30.photobucket.com/albums/c348/johnluard/cw2.jpg
http://i30.photobucket.com/albums/c348/johnluard/cw3.jpg
http://i30.photobucket.com/albums/c348/johnluard/cw2.jpg