supershingler
09-07-2009, 09:34 PM
is there a way to draw lines at a true 30 degree and 60 degree angle in the designer layout?
the following project is what i have so far but i would like to add a hole at 30 and 60 degrees from the center point that intersects with the inner circle, almost like a clock layout only with more holes.
im making a jig to flute some round columns for a fireplace front i am building.
any help appreciated
kendall
the following project is what i have so far but i would like to add a hole at 30 and 60 degrees from the center point that intersects with the inner circle, almost like a clock layout only with more holes.
im making a jig to flute some round columns for a fireplace front i am building.
any help appreciated
kendall