View Full Version : another problem with pattern
I used a dragon pan that Ken had put up and a fishing rod holder someone else had. Both on these only carved about 1/16th deep flat carve area? On designer they show as having depth to them but they carve flat. did it on both units and on difference cards
Also I formatted a card and it took like zip and it said it was formatted I thought I saw somewhere that formatting took a bit of time
Thanks
fwharris
08-30-2009, 11:46 PM
I used a dragon pan that Ken had put up and a fishing rod holder someone else had. Both on these only carved about 1/16th deep flat carve area? On designer they show as having depth to them but they carve flat. did it on both units and on difference cards
Also I formatted a card and it took like zip and it said it was formatted I thought I saw somewhere that formatting took a bit of time
Thanks
Hess,
Post your MPC so we can look at it...
Hess,
Post your MPC so we can look at it...
Here it be
I remember Ken saying that it could be cut out with a hobby knife. That about as thick as it is craving just barely removing anything
Kenm810
08-31-2009, 10:07 PM
Hess,
I remember carving the Dragon file a least 6 ot 7 times
without any problems. I'm not sure why it's giving you problems now.
I just compared the file you posted and the one I used and they'er the same.
Try this one, I just re-worked the file -- take a look at the new version.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.