PDA

View Full Version : Design Help



undrtkr
08-26-2009, 09:21 AM
THe attached photo a friend wants carved. The problem I can't overcome is that when changed to a grey scale, the weeds growing out of the wall end up being carved the same as the joints between the blocks, either above or below. How can I get the weeds to extend out and the joints carve into the piece. My only photo softwares are Paint Shop Pro and Paint.net. ANY suggestions would be greatly appreciated. Tom

eromran
08-26-2009, 09:30 AM
Can you post a bigger picture can't really see it.

undrtkr
08-26-2009, 10:27 AM
Every time I resize the picture to meet upload requirements I get something this small. I must be doing something wrong.

Kenm810
08-26-2009, 11:06 AM
undrtkr,

If you have a graphics program something like photo Shop,
you might trying to use the magic wand to hight light the
the foliage, and reverse the color to make lighter than the wall,
then it will stand out from the wall a little when it's carved.

Just a thought

undrtkr
08-26-2009, 11:06 AM
Hopefully this will be better