What am I missing

[Carving Hodag]

The bottom of the arcs do not match on both ends, all my points are the same, or am I missing something.

[HighTechOkie]

Try attaching the actual mpc file rather than a screenshot. I suspect the nodes at the ends of the lines don't match up, but need to see that mpc to know for sure.

Rob

[Carving Hodag]

Here is the mpc

[dbfletcher]

Try add in an attachment to the center radius "+" marks... you will then get them to be the same.

Doug Fletcher

[Old Salt]

just pull green dot on left down will match with same radis .
show .5 grid to see.

[Woodhacker]

Hey Hodag...attached is a fixed copy of your mpc. Hope it helps.

Richard