afurda
08-22-2009, 08:32 AM
Just thought I would throw this out and see if anyone has encountered this.
While following the suggestions of support about getting the scanning probe to work, the machine went non-functional. I am awaiting their reply for the next round.
Upon turning the power switch on the Y and Z trucks travel to their farthest and lowest stop positions, the drive belts X run constantly counter-clockwise.
The keypad does not control anything and there is no alphanumeric display.
Shutting the machine off is the only option. Everything is tight, reseated, and clean. ? Anybody
A. Furda
While following the suggestions of support about getting the scanning probe to work, the machine went non-functional. I am awaiting their reply for the next round.
Upon turning the power switch on the Y and Z trucks travel to their farthest and lowest stop positions, the drive belts X run constantly counter-clockwise.
The keypad does not control anything and there is no alphanumeric display.
Shutting the machine off is the only option. Everything is tight, reseated, and clean. ? Anybody
A. Furda