albertk836
08-14-2009, 02:42 PM
First, I have had the system for about 1.5 weeks.
My first project went well. My second, I am having an issue with.
I have created a Sundial using the software. I have 11 lines from the center pointing to the time numbers near the edge of the board. For some reason 2 lines (the ones pointing to 9 and 10 on he attached file) will not cut-out.
At first I thought it was a scaling issue. I am now using a board the correct size where I get the "Keep Original Size" option, and select it. I have compared the lines that don't cut to the ones that do and cannot find any differences.
I also have gone as far as to re-create the project totally with the same issue, with one exception. The two lines that don't show up moved to two different numbers.
I am at a loss.
I have also updated to the latest software (1.152) and firmware. The attached file will not cut the lines to 9 or 10 yet on the screen they look fine.:confused:
My first project went well. My second, I am having an issue with.
I have created a Sundial using the software. I have 11 lines from the center pointing to the time numbers near the edge of the board. For some reason 2 lines (the ones pointing to 9 and 10 on he attached file) will not cut-out.
At first I thought it was a scaling issue. I am now using a board the correct size where I get the "Keep Original Size" option, and select it. I have compared the lines that don't cut to the ones that do and cannot find any differences.
I also have gone as far as to re-create the project totally with the same issue, with one exception. The two lines that don't show up moved to two different numbers.
I am at a loss.
I have also updated to the latest software (1.152) and firmware. The attached file will not cut the lines to 9 or 10 yet on the screen they look fine.:confused: