View Full Version : Error
I FINISHED SOMETHING TO BE CARB , BUT WHEN I OUTLINE THE PIECE IN SOME AREA FROM ONE SIDE I CAN CUT BUT THE OTHER SIDE DON'T ALLOW ME. JUST CAME BIT. I UPDATE THE VERSION BECAUSE THE SAME WAS HAPPENING WITH THE OTHER VERSION. AND THIS IS OLD PATTERN.:confused:
Digitalwoodshop
08-11-2009, 12:23 PM
It will only allow you to do a cut path on the top side of the board. It will do all the carving on the back first with a 2 sided carve then when you flip it to the front it will carve then the last thing it will do is the cut path.
Check out the Tips and Tricks for some other great info.
Good Luck,
AL
Is Not That . Let Me Attached If Happens Again WITH YOU. WHEN YOU OUTLINE COME THE PATH . NOT ALL THE PATH LET ME CUT EVENDO THE OTHERSIDE OF THE PATTERN YOU CAN DO
THANKS FOR YOUR RESPONSE
Icutone2
08-11-2009, 02:23 PM
Something like this?
Lee
Icutone2
08-11-2009, 02:31 PM
Or maby this?
Lee
do you see what i intend to tell. when i have the 1.43 i think that this was the previous i can make all the cut through the pattern. probably now i have to cut out of the machine.
i know that my english is not too good
hi lee sorry, now i see that instead of bit i can make the cuts. how you do it. or what was happening.
thanks
hilda
cestout
08-12-2009, 01:12 PM
The way I hide holes in something like this is to place a carved out region set as about maybe .6 deep behind each of the holes. Then when you outline the pattern, you have to select also each of these carved out areas. You will wind up with only the outline of your main object.
then make it a cut path.
Clint
cestout
08-13-2009, 05:21 PM
OK, her it is with the holes hiden with patches.
Clint
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.