wasacop75
08-10-2009, 06:59 PM
I just noticed that the Z truck was extremely warm to the touch when i finished my carve tonight. The flex cable was not warm at all.
Any bright ideas as to what is going on now?
Also: I noticed during this carve the bit was moving across the wood but did not touch the wood.
Aslo: When i did the cut path, it went around one and 1/2 times and then broke apart.
Is this a problem with the 1.150 or am i an idiot??
here is the carving
Any bright ideas as to what is going on now?
Also: I noticed during this carve the bit was moving across the wood but did not touch the wood.
Aslo: When i did the cut path, it went around one and 1/2 times and then broke apart.
Is this a problem with the 1.150 or am i an idiot??
here is the carving