PDA

View Full Version : I have a screw loose



nwn
04-06-2006, 03:57 PM
I just completed my latest project, and when I removed it from the machine there was a tiny screw laying on top of the piece.

It's smaller than a #2, and about 3/16 inch long. The project completed successfully without the screw in place, but it must belong somewhere. Looking around with a mirror, I don't see any place where a screw isn't. Where does it belong?

Neal

djochim
04-06-2006, 06:28 PM
Neal,
It sounds like you have found an M2 x 6mm long screw. There are only two locations where this screw is found, both of which are on the truck that translats up and down (what we call the z-truck). The most likely candidate is at the location indicated by the red arrow in the attached PDF file. If this is not the culprit please give us a call at 713-473-6572 and we can explore further.
Regards,
David

nicobie
04-06-2006, 06:41 PM
Now that is a cool reply.

A picture really is worth a thousand words :D

nwn
04-06-2006, 06:46 PM
That was it! Thanks for the quick solution.

Neal

Dan-Woodman
04-07-2006, 03:49 PM
I tried to download it but did't get anything.later Daniel in Missouri