View Full Version : Hello everyone
mailman
04-05-2006, 07:00 PM
Hi just ordered a CarveWiright and cant wait to put it to the test. I am ready to start work with it tomorrow (to bad I was told it would take a couple of weeks to get the machine). I know I will have a million questions for you guys so I am giving yall a couple of weeks warning. I have downloaded a trial version of the software and am practicing with it. Hopefully everything will be setting on ready when the machine arrives.
Later :D
Dan-Woodman
04-05-2006, 09:28 PM
Hey Mailman
As of now ,you can read the owners manual on the web site also.
later Daniel in Missouri
mailman
04-05-2006, 11:08 PM
I have looked around the website but I do not see anything about downloading a manual. I would appreciate it if you would direct me to the download.
thanks
yenne
04-06-2006, 04:04 PM
It's on the Downloads page:
http://www.carvewright.com/downloads.html
mailman
04-06-2006, 10:03 PM
Hopefully you just added this to the downloads section. This was the first place I looked and I don't think it was there when I looked. I do appreciate you telling me where the manual is. I have downloaded it and this will give me more of a headstart.
thanks :D
yenne
04-07-2006, 09:50 AM
Hopefully you just added this to the downloads section.
Yes, it was added just a few days ago due to popular request.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.