Mike Witt
08-08-2009, 03:19 PM
I have a board that measures 9.000 square and 1.000 thick
I want to carve a "dished out" circle of 8.500 diameter in the center. The edge will begin at board surface and be .750 depth in the center.
I know I've seen this on here before but I can't locate it at this time
Any and all assistance will be muchly appreciated.
Thanks
Mike
PS I understand about the additional length and such of the project board but these dimensions are my final finished project
I want to carve a "dished out" circle of 8.500 diameter in the center. The edge will begin at board surface and be .750 depth in the center.
I know I've seen this on here before but I can't locate it at this time
Any and all assistance will be muchly appreciated.
Thanks
Mike
PS I understand about the additional length and such of the project board but these dimensions are my final finished project