View Full Version : Any suggestions
Bubbabear
08-05-2009, 09:39 AM
any suggestions on how to stop this from happening this is number 4 of these cables. one that came on the machine one LHR replaced and two I have replaced the one shown is last one replaced at factory while under warranty
Thanks
Digitalwoodshop
08-05-2009, 09:51 AM
You could add a strip of rubber tape to both sides of the cable after it is in the holder to place the bend point out further and hopefully is gentler.
AL
Bubbabear
08-05-2009, 11:04 AM
also would this break cause the z axis errors 298 and 308
bergerud
08-05-2009, 12:49 PM
It looks like the ribbon is twisted. This might cause too much stress at the end. I think the ribbon should be vertical.
Digitalwoodshop
08-05-2009, 01:11 PM
Cable should be level..... If too high, then added stress can snap the wires....
Yes, that can cause a Z Error code.
AL
Bubbabear
08-05-2009, 01:59 PM
There is how it was when I opened the cover. First time top has been off since last time it was in shop for them to repair z bundle and some other things
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.