View Full Version : Jog to position
applik
04-02-2006, 07:54 PM
Removed
pkunk
04-03-2006, 09:38 AM
check your feed rollers to see if they're turning when you hear that faint noise. When it measures the board, it slows down near the end and I've noticed that with some boards I have to help it a little with a gentle nudge.
applik
04-03-2006, 11:20 AM
Removed
cmorlier
04-03-2006, 12:20 PM
Hi Shari,
What version of firmware are you running (you can check the version under the options menu)? If you are not running 1.025, try upgrading and see if it fixes your problem.
In the past, we had a bug that caused it to get stuck around the edges of the allowed area. It would stop or buzz a little when it got stuck.
If you are running 1.025, then maybe we missed a condition that could cause this bug. Let me know what 1.025 does.
applik
04-03-2006, 12:37 PM
Removed
cmorlier
04-03-2006, 02:25 PM
Okay, I will try to reproduce this at my end.
think i had the same problem. was putting a 6x6 project on a 8x16 board on the program and had a 8x16 board in the machine. had to change the board in the computer to the same size as the project (both to 6x6). then i could jog on the 8x16 board. hope this helps, hal
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.