PDA

View Full Version : Stall On Y Axis I think



don
03-26-2006, 09:30 AM
I was having problems with the router bit stopping, which was caused by a short cable. This was replaced and also upgraded to the 1.025 software.
Since then I can load a new project, load the board as directed and the machine will go into its homing positions and then move about 1 to 2 inches to the right and stop. I think that this may be on the board measuring setup. In any case it will stall at this point and return me to the project menu. If you start over it will repeat the same process. I have tried formatting the card and new projects with the same result. Any one have any suggestions. I think that the y and z flags are ok. Thanks for any help