View Full Version : Layout Question
James RS
07-18-2009, 05:39 PM
I know you can use a 14.5" wide board in the machine, can you carve a 14" piece in that same direction?
Thanks,
Jim
AskBud
07-18-2009, 06:09 PM
You must consider the "Rails" you will have remaining, for the "rollers to maintain compression. Some carves, that do not pass under the rollers, may work well. However, when that carve passes under the roller, you do not have much of a lip/rail remaining.
AskBud
James RS
07-18-2009, 06:53 PM
Bud the only reason I ask is the shape is basically a squashed triangle with an angle on the long edge. So I figured it would carve a little quicker
AskBud
07-18-2009, 07:02 PM
It will depend upon the length of the short leg of the triangle.
AskBud
James RS
07-18-2009, 07:44 PM
It's approximately .375"
AskBud
07-18-2009, 08:28 PM
It's approximately .375"
Go for it :=)
AskBud
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.