View Full Version : Prob have to solve FAST!
flyingemt
07-05-2009, 12:25 PM
I have a mpc drawing a friend did for me which is perfect for a simple carve region. Problem is, I have to rotate it 90 CCW for it to be placed correctly on project, have pulled what hair I have left out, any suggestions? I am attaching the MPC.
Flying.........
DocWheeler
07-05-2009, 12:41 PM
flyingemt,
Not sure if I did what you wanted, I made a pattern that you can rotate as you please.
flyingemt
07-05-2009, 12:44 PM
Doc,
Thank you soooo much, but what version are you running in which you created it ?
Kenm810
07-05-2009, 12:49 PM
Is this what you need
I removed all the restraints and made it into a pattern
to rotate it CCW 90 Degrees
Ps. Hi Doc, me too
flyingemt
07-05-2009, 01:14 PM
Gentlemen,
Thank you again for fixing that part for me, however, this is a complicated project I think. I have all my other settings correct, this will actually carve the entire board to created the raised logos and lettering, however, the badge area needs to be a .130 carve region to place an actual chevron in with hot glue. Any thoughts? Am I just not compensating for the depth being removed for the raised items?
Flying.......
Attaching the final project mpc
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.