PDA

View Full Version : memory card



ditchdoc
03-15-2006, 09:21 AM
I have had a small problem uploading projects to the card. About half of the time, when I try to upload a project, I get an error message stating that the project can't be written because the card is damaged. I then remove and replace the card and try again. It takes two or three tries and the project will finally write. Has anyone else had this problem? I'm wondering if the card is actually damaged or if it's a program glitch. Thanks to anyone who can help.

eknight
03-15-2006, 11:51 AM
Sounds like it’s a defective flash card, probably a bad solder joint. We will get one out to you today.

ditchdoc
03-15-2006, 01:18 PM
Thanks. I appreciate the fast service. I will send the old one back. I was working on my first money-making project when this happened. I am making a series of trophy/plaques for shooting matches. They are going to be late, but maybe the upside will be that the other bits I ordered will arrive and I can make the lettering look better. :roll: Stuff happens.