PDA

View Full Version : Minimum board thickness



lpcsales
03-10-2006, 09:16 AM
Why is the minimum board thickness .5"? Would I be risking damage to the machine if I ran .25" thk. boards?

nicobie
03-10-2006, 02:20 PM
I think with the newest version of the software you can now use 1/4" boards.

yenne
03-11-2006, 01:11 AM
You are correct -- the requirement is now 1/4". The thickness limitation is due to mechanical issues with the compression rollers.

lynnfrwd
01-05-2017, 10:56 AM
This information is VERY OLD and incorrect. The minimum thickness that can be put into the machine is .5". You can put 1/4" into the machine, but it must be on at least a 1/4" thick sled to take it up to the .5".