aj
03-06-2006, 10:53 AM
I downloaded the software to get a feel for it.
On a drawing flat board 14x17
Im selected a 1/2" bit straight cut using a depth of .36 and inset .25 from the board edge. Now on the 3d rendering it shows a groove instead of a clean cut off the edge.
could the settings from board setup being constricted to 1/8" bit cause this?
Thank you
aj
On a drawing flat board 14x17
Im selected a 1/2" bit straight cut using a depth of .36 and inset .25 from the board edge. Now on the 3d rendering it shows a groove instead of a clean cut off the edge.
could the settings from board setup being constricted to 1/8" bit cause this?
Thank you
aj