View Full Version : Pls Help
:confused:I DON'T KNOW WHAT IS GOING ON . I HAVE THIS PROJECT THAT I HAVE TO FINALIZE. THE NAME CARMYSHA WHEN I DID THE TRIAL CAME VERY GOOD. BUT WHEN WE CARVE THE PIECE THE LETTERS CAME BAD. I HAVE SUCH PRESSURE OF TIME I HAVE TO BE FINALIZE IT FOR TOMORROW. AND REALLY I DONT NOW WHAT IS GOING ON.
mtylerfl
06-08-2009, 02:27 PM
:confused:I DON'T KNOW WHAT IS GOING ON . I HAVE THIS PROJECT THAT I HAVE TO FINALIZE. THE NAME CARMYSHA WHEN I DID THE TRIAL CAME VERY GOOD. BUT WHEN WE CARVE THE PIECE THE LETTERS CAME BAD. I HAVE SUCH PRESSURE OF TIME I HAVE TO BE FINALIZE IT FOR TOMORROW. AND REALLY I DONT NOW WHAT IS GOING ON.
Hello,
Try making the "Carmysha Holmes, MD" CENTERLINE Text just like the other text you have on the board.
FINGERS
06-08-2009, 02:29 PM
If you make the depth of the letters .090 and height 90 and put a small draft on the letters and carve it at best.What kind of wood are you carving?
i have no centerline. we carve in mohagany
mtylerfl
06-08-2009, 03:08 PM
i have no centerline. we carve in mohagany
Your mpc had CENTERLINE assigned to all the text except for the customer's name.
You'll need to change all the text to RASTER. Perhaps that's why the text was not coming out correctly.
ok. the other letter was made by one of the forum. also carmysha is raster
cnsranch
06-08-2009, 03:20 PM
Use the attached - raster will chip out too much for your liking.
when i try to upload come a message that camysha has 0 deph or hidden
cnsranch
06-08-2009, 03:40 PM
Try this attached one.
You don't have centerline but you do have a 60 degree v-groove bit, right?
yes i have. if i use what deph i should use
ok i place the bit thanks
thanks very much it came good.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.