View Full Version : Clean Y Axis rails?
lostinthefrost
05-16-2009, 05:43 PM
I just put a new Ztruck in 2 days ago. Before I put it in, I scrubbed down everything. Now every few mins I am getting a "clean y axis rails" error.
Is something too tight?
the y rails are clean
Should I lube them?
Any ideas?
DocWheeler
05-16-2009, 07:19 PM
lostinthefrost,
The machine senses too much energy needed to move the Y truck I think.
When mine did that I found that the big gear on the Y motor was wearing into the cover because the other end of the shaft had worn off.
Anyway, something is causing the motor to use too much amperage.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.