states patterns

[skeeterman]

dose anyone have the states in ptns, for instance, ptn of the state of Arkansas, Tenn, Texas ,ect, ect. wanting all 50 states thanks
steve

[PCW]

Someone posted this a while ago. Maybe you can edit it so it to work for you.


US Coin Map (http://forum.carvewright.com/attachment.php?attachmentid=2461&d=1173583398)

[fwharris]

dose anyone have the states in ptns, for instance, ptn of the state of Arkansas, Tenn, Texas ,ect, ect. wanting all 50 states thanks
steve


Steve,

try this link.. Found it by doing a search "state patterns"

http://forum.carvewright.com/showpost.php?p=10900&postcount=3

[Digitalwoodshop]

When I needed PA I just found a picture of the state and made it into a .ptn and brought it into Designer on a 14 inch board. Made it as big as I could then took the line drawing tools and connect a line and outlined the whole pattern making sure to connect the last node.

Deleted the .ptn as it was just a reference.

Turned the outline into a Vector Cut for my project but I could have used a Cut Path.

I have done that with a few things like a wine bottle and glasses.

AL

[fwharris]

Al,

The same thing can be done with these. I checked a few and some do have some junk/spots around the patterns so they would not carve good as patterns. But as outline and set your vector bit they should do just fine...

These have been in the forum for a long time...

[Rickrljones]

Here is a ZIP file with all 50 states included. Hope this is what your looking for.

[TerryT]

All 50 are posted in the pattern sharing depot.

[skeeterman]

Thanks everyone, I opened up the paper clip on pattern sharing and looked for the states and could not find them, thanks for all the help
steve