PDA

View Full Version : Cut motor magnet retainer



mfdchief
04-20-2009, 08:59 PM
Well just as suspected by the good folks on this forum, my cut motor magnet was MIA. Found it clinging to the front bearing. The weird part is that the retainer wrap seemed to be in very good shape. I called hardware support and waited on hold for longer than I had for my lunch period, so I left a message but didn't get a call back, so in a second call I made contact with sales and ordered the new fangled retainer. The down side is that it is back ordered. They said it does not come with instructions but to call back to support when it arrives for help.

In hopes of avoiding being put on hold for a long time again, does anyone have a blow by blow and how to install it when it shows up?

BTW My machine only has 28 hours on it but is out of warrenty time wise.

Thanks for any help.

Mark

Digitalwoodshop
04-21-2009, 08:32 AM
It just slides on the end once you remove the motor and open it up.

AL

mfdchief
04-21-2009, 12:22 PM
Thank you Al, sounds pretty simple then.

Mark