PDA

View Full Version : Regarding the Bocsh Eliminator


dvel56
04-12-2009, 11:12 PM
Regarding this QC change out instead of cutting the nut off the shaft Etc.
Would it be possible to turn a shaft to fit and then thread it the same as the Bocsh Eliminator Chuck
If someone can get me the shaft specs I have somone who could turn one

Dvel
Pratyeka
04-13-2009, 05:58 AM
Regarding this QC change out instead of cutting the nut off the shaft Etc.
Would it be possible to turn a shaft to fit and then thread it the same as the Bocsh Eliminator Chuck
If someone can get me the shaft specs I have somone who could turn one

Dvel

Do you mean to replace the original spindle in the Z-truck? That would be more costly but feasible. There would be no advantage as far as I can see. Nothing in the Eliminator can wear out or break.