View Full Version : Too high
jcaravella
04-06-2009, 02:39 PM
Ok so it seems i cranked my machine too high up to put a board under it and now I cannot lower it. I do remember reading somewhere how to bring it back down but cannot find it anywhere.
Any help is appreciated. TIA.
joe
Kenm810
04-06-2009, 02:56 PM
Use the hole in the far vertical screw post
to manually start the head back down
http://forum.carvewright.com/attachment.php?attachmentid=21401&d=1237749221
mtylerfl
04-06-2009, 03:16 PM
Ok so it seems i cranked my machine too high up to put a board under it and now I cannot lower it. I do remember reading somewhere how to bring it back down but cannot find it anywhere.
Any help is appreciated. TIA.
joe
Hello,
Check page 53 of the most recent Owner's Manual (http://www.carvebuddy.com/PDFs/CarveWright_manual_rev139_03-02-09.pdf) which was released in March of this year (2009)
jcaravella
04-06-2009, 03:54 PM
Thanks everyone!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.