Has anyone tried this?

[crazyhammer]

I was wondering if anyone has tried to soak there project board with a thinned urethane or some other finish that would allow the board to soak in the resin and harden before carving. I was reading an article a while back where they were using varnish and thinning it drastically so that it would penetrate a cutting board. I would try it but I've been waiting 4 weeks for a z truck replacement so I thought I would ask. I was curious if this would allow you to get a better finish straight out of the machine.

[Digitalwoodshop]

Same as sanding sealer.

You can delete the post in the other Thread since you started it.

Follow the instructions at the bottom after edit.

AL

[crazyhammer]

Thanks for the reply, I'll do a search on sanding sealer for more info. I tried to delete the other thread but couldn't figure it out.