jcaravella
03-25-2009, 08:14 PM
I purchased a basic bit set from Sears when i purchased the Carvewright (CompuCarve) It came with standard 1/2" & 1/4" Bullnose 45% and 60% bits and the 3/8" straight bit.
Can the additional Bits supplied in the Full set be purchased seperatly? eg: Classic bit etc. Didnt see then listed seperately on the CW website. Or can I use generic bits and the adapters. If so where would i find the specs for the bits the CW has programed into it.
Is there a way for the CW to learn new bits it does not have built in memory?
Can the additional Bits supplied in the Full set be purchased seperatly? eg: Classic bit etc. Didnt see then listed seperately on the CW website. Or can I use generic bits and the adapters. If so where would i find the specs for the bits the CW has programed into it.
Is there a way for the CW to learn new bits it does not have built in memory?