rmiller2
03-15-2009, 01:47 PM
I've sucessfully carved my first few projects and have a question. Why does the machine ask for a vector bir selection if I am not using vector graphics?
My last project only used the carving bit but the machine asked me to change the bit to the vecor bit. I did and it did its little homing routine and then asked for the cutting bit without doing any vector carving. I place the cutting bit in, it did its little dance, then asked for the carving bit without doing any cutting.
Is there a way to prevent this if you are only using one bit in a project? It sure would save some time.
Thanks,
R.
My last project only used the carving bit but the machine asked me to change the bit to the vecor bit. I did and it did its little homing routine and then asked for the cutting bit without doing any vector carving. I place the cutting bit in, it did its little dance, then asked for the carving bit without doing any cutting.
Is there a way to prevent this if you are only using one bit in a project? It sure would save some time.
Thanks,
R.