View Full Version : Learning the hard way
wasacop75
03-14-2009, 05:50 PM
With my first project carve that i was 77% thru, i have just learned that you have to watch what buttons you hit. I am doing a three hour carve for a wedding present and hit the stop button twice by mistake.
Hey, at least i have time to go eat supper before i have to watch again.
:(:(:(:(:
TerryT
03-14-2009, 06:40 PM
I think most of us have done that at one time or another. You can redo the carve as is or you can put a carve region set to 0.00 over the area already carved.
wasacop75
03-14-2009, 07:45 PM
I am just redoing the carve. its only time and what else do i have to do on a Saturday night???
wasacop75
03-14-2009, 09:54 PM
As the carving gets closer to being finished, I see that the two hearts are not there. They show on the pattern, but not carved.
What did i do this time?
Hexe SA
03-16-2009, 04:05 PM
As the carving gets closer to being finished, I see that the two hearts are not there. They show on the pattern, but not carved.
What did i do this time?
hard to tell without the file, too see why they are not showing.
Eva
wasacop75
03-16-2009, 08:16 PM
Well,,,, after it did not carve correctly, it was all deleted and i will have to start over. Now the LOML wants a new design of a rearend of an old car with the names and just married carved on it. now all i have to do is find the old car rearend pattern..
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.