Frustration.

[jacanah]

Hey all, just got my machine back up and running after replacing the z-truck. Now, I have a stuck back roller. The micro switch is not being activated keeping the roller compressed. I'm assuming that is also what is keeping the board sensor from working correctly as it's not giving any numbers during a sensor check.
Anyone have any suggestions? Thanks in advance.

Scott.

[supershingler]

double check your flat cable and make sure you have it installed correctly and not tipped up or down a little

i had a board sensor problem and that is what my problem turned out to be

kendall

[jacanah]

Thanks Kendall,

I'll start there. I may have repositioned the flat cable when installing the new z-truck.