View Full Version : New Ztruck
837kenny
03-02-2009, 04:28 PM
Does anybody know if they fixed the problem with spacer in the lower spindle bearing falling out? I have replaced it twice with refurished ztruck only to have them fail within 20hrs of carving each time.
Than you
Kenny
Digitalwoodshop
03-02-2009, 04:35 PM
That is a very good question....
I say call LHR on that one.... I had one fall out last summer....
AL
roughcut
03-02-2009, 09:00 PM
Mine fell out after I changed my QC. I think because I over heated everything there is probably blue dope or something on the ring..Just my theory.:)
837kenny
03-02-2009, 09:46 PM
Roughcut did you replace the ztruck or were you able to fix it
roughcut
03-03-2009, 01:03 PM
Roughcut did you replace the ztruck or were you able to fix it
I finaly replaced it because the ring never did fit tight. there was back and fourth movement in the spindle not a lot but I didn't think the ring would stay in. I still haven't sent the old one back for the core charge . Must call CW and find out how to go about that.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.