View Full Version : Does probe need it own software?
redeye_joe
02-17-2009, 09:46 PM
I have found a guy that has a probe to sell, but he has no software? Does it need an licence or software, or can i use it with the design software that comes with the machine. Is there a licence to use it with machine?
Dan-Woodman
02-17-2009, 09:50 PM
The software for the probe ,last time I checked , was $199.00.
later Daniel
redeye_joe
02-17-2009, 09:51 PM
So there is seperate software for the probe??? Not the designer software that comes with machine?
thanks
Dan-Woodman
02-17-2009, 10:00 PM
You normally by the probe and software as a set, but yes the software is available seperately for $199.00. The probe does need it's own software.
later Daniel
SeaCapt97
02-18-2009, 09:42 AM
Joe,
The probe software is already embedded in the Designer Software. You will need to activate its license. That's where the $199.00 comes in. You can buy a brand new probe with license for $249.00 at Amazon. Don't pay too much for the used probe.
Bill
Dan-Woodman
02-18-2009, 06:23 PM
Thanks Bill
Thats what I should have said, but being the non-computer savy type person I had to adlib.
later Daniel
ChrisAlb
02-21-2009, 05:02 AM
Plus, didn't I read in here a while back that the probe software license isn't transferable from one owner to another?
If so, I'd be careful about buying a second hand probe. Wherever you get it, new is the best way to go I'd think.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.