new computer wont boot up carvewright project

[ericsilk]

I installed software on a new computer. Made a project and uploaded it to my memory card and took it out to be carved. The carvewright would not boot up. The screen looked like it was on but no welcome to the carvewright and no projects would show. Took card out and deleated the project, done from the new computer. now everything is back to normal. Do I have to do anything so the carvewright recognizes projects from my new computer.
thanks Eric

[jcorder]

you need to make sure you are running the same firmware on the new computer as you were on the old. If you loaded an older version and then did not upgrade, it might make a difference due to firmware issues. Just a thought

Jeff

[ericsilk]

I just upgraded software to 1.132 on old machine and installed the same software for the first time on my new machine. Thanks for reply