How Many O Rings Are There??

[cnsranch]

I need to replace the O ring on the brass roller (just one more reason to carve above 50 degrees), but I found a larger one on the floor under my CW. Can't say that it came from the machine, but it could have.

Any ideas?

[Digitalwoodshop]

I need to replace the O ring on the brass roller (just one more reason to carve above 50 degrees), but I found a larger one on the floor under my CW. Can't say that it came from the machine, but it could have.

Any ideas?


As far as I have seen the only O ring is the one on the Brass X Roller.

AL

[cnsranch]

FYI, I did find one listed in the parts manual, it shows to be under the lockdown lever handle. I haven't looked to see if I have one there, but that could be the culprit.