RabidRed
02-09-2009, 06:53 PM
I just got my Carvewright and started having problems with the QC. The flanges which the release tool pushes against, started chipping with the first bit change. The release tool has also become geeded up. The QC is just hard to use.
When calling support I found that the QC is not covered in warranty. My first thought is that part must go out on a regular basis.
Any one else have trouble with this???
When calling support I found that the QC is not covered in warranty. My first thought is that part must go out on a regular basis.
Any one else have trouble with this???