Needing advice from the " Pros "

[Mike Witt]

Is it possible and what are the techniques to make a sign reading vertically such as an address number reading from top to bottom.
I can't seem to find anything about this in any searching the forums and I would certainly appreciate any advice.
Thanks in advance
Mike:roll:

[fwharris]

Mike,

One number at a time and position it as needed.

[RBeau1954]

When you put your numbers in while designing your board, highlight the number, go to layout and near the bottom of the drop down screen you will see flip and rotate, use that feature to rotate the numbers any way you want.

[Mike Witt]

Thanks guys, much appreciated, I had done it that way but just thought I'd ask the pros if there was a more simplified and less time consuming way to get the results.
Thanks again
Mike

[Amonaug]

In the text editing you can simply use the enter/return key after every number to make them vertical such as

4
5
7
6

[Digitalwoodshop]

E
A
S
Y
:)

[roughcut]

Another thing to know if you set justification left, the left side of the letter will be in line . If you set justification center the center of the letters will be in line as shown in the MPC:)