Continue operation?

[dominulus]

Midway through a project, the machine has been stopping and asking me if I want to abort or continue operation. When I "continue operation" everything works well for another 10 minutes or so until it stops and asks me again.

This happens with both carve bits and vector bits.

I've checked the head pressure, which is fine; no X-axis stall errors, either.

Any ideas?

[Amonaug]

What is the message it gives besides continue/abort?

[Digitalwoodshop]

Did the open Cover Switch vibrate?

AL

[dominulus]

My recollection is that it simply asked if I wanted to abort or continue.
I does sound like the same message that one gets after the request to close cover before continuing. I'll check the cover switch. Thanks!

[Dan-Woodman]

I been getting that too. I took both switchs loose , looked inside the one by the keypad, no sawdust. Put everything back and still doing it. I think I need to push the keypad side switch closer to the cover , cause when I push down on the cover it changes to continue.
later Daniel