Clogged Board sensor

[55president]

I Kept getting the Clear board sensor message,Cleaned it as best as I could on the outside, still getting error message,Doing a Sensor test got 32 so Finally taking it off to look at it and One side is totally clogged.I can't seem to get
at the dust on the left side, vacuumed shook it ,etc..I don't want to damage the part ,does it come apart?
Thanks

55 president

[Digitalwoodshop]

This is an EXTREME but it worked for me.... Took a sharp knife and sliced down the back of the plastic removing that bump of plastic in the back. I did it carefully enough that I could then slide the plastic window out and clean it. I then used Tape to reseal the back, catching a piece of the window holding it in place. It's not pretty but it worked for me.

AL