Shering my projects

[szczyglic]

I recently created more than 20 new projects for cabinet door fronts.
Since my machine is down and I have ti wait for spares I can shere some of it with someone who will send me a picture of my project done.
Here we go with 2 samples. More on request.
Regards,
Grzegorz "Szczyglic"

[AskBud]

Here is a quick link to a conversion chart.
http://www.manuelsweb.com/in_cm.htm
AskBud

Perhaps the Monitors will post the Link in the CarveWright section of the Forum.

[szczyglic]

Conversion of CM to inches. Thank you for downloauds.

[Amonaug]

Just a bit of advice. Try adding "feather" to the carve regions so they slope inward towards the patterns instead of forming a flat 90 degree drop. Just my opinion that it looks better but up to you.

[brdad]

I have to try some doors sometime if I can find the right project.

You can also convert different units just by typing your request in a Google search - pretty easy, especially if you already have a search box on your toolbar.

4.6 inches in cm
4 11/16 inches in mm
128 CM in inches
24 gallons in liters
32 Celsius in Fahrenheit
100 cubic feet in cubic meters
6 acres in sq feet
100000 ounces in tons